PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING URAD FOR THE FIRST TIME!

1)  Remove lid from jar and remove the sponge.

2)  Remove the inner seal and scrape any products off the seal and put it back into the jar. Retain the inner seal (don't throw it out, it will keep your product from drying out) If the oil and wax are separated, replace the seal and shake the jar well (it will sound like your shaking a container of yogurt). Remove the inner seal again, and let it sit for a few minutes. After a few minutes, your URAD will go back into a paste form (ONLY do this if the oil and wax has separated, or your product has sat for more than 6 months).

3)  Touch the end of a clean, dry sponge into the URAD. Scrape all of the excess back into the jar(scrape it against the lip of the jar, and this will remove all excess product) so that the sponge is moistened, but with no excess visible.

4)  Using the moist end of the sponge, wipe leather in long strokes either up and down or side to side (avoiding circular motions). When the sponge drags on your leather more product is needed, repeat the above steps.

5)  When you have finished using URAD, wash your sponge under warm water (DO NOT USE SOAP OR CHEMICALS as these may harm your leather goods). Replace the inner seal, put the top lid back onto the URAD jar and seal tightly. Allow the sponge to dry completely before reusing or re-storing back into the jar.